Project of security alarm system for fuel and lubricant

In this project, a security alarm system for a fuel and lubricants warehouse has been developed.
The security alarm system for the premises is implemented using the following equipment:
- IO102-4 (magnetic contact detector) - blocking doors and windows from opening;
- DIMK (inertial magnetoelectric sensor) - blocking windows from breaking and removing glass;
- DPMGR-2 (position sensor) - blocking gates from opening;
- Foton-9 - volumetric optical-electronic detector, detection zone 10x12 m, installation height not less than 2.3 m from the floor, powered by a 12 V DC source, issues an alarm notification by opening the contacts of the executive relay, current consumption 15 mA, installation location - wall.
All alarm loops are routed to the Signal-20P device (No. 16), installed in the electrical panel.
The detectors of the "Diesel Fuel Pumping Station" room are included in the intrinsically safe circuit of the "UPKOP 135-1-1" device installed in the "Electrical Panel" room. The output of the "UPKOP 135-1-1" device is included in the loop of the "Signal-20P" device (No. 16). The "Foton-9" detectors are powered by the RIP-12 backup power supply unit with a built-in 17 Ah battery. The output voltage of the unit is 12 V, the maximum current is 3 A. The total consumption in the 12 V circuit is 0.125 A.

The alarm signal from the Signal-20P device is transmitted via the RS-485 interface to the Orion workstation installed in the security room of the administrative and amenity building

File format: dwg, tif (AutoCAD 2010 is not editable)
Note: the original *.tif files must be in the same folder with the *.dwg project file

Download the file "Project of security alarm for a fuel and lubricants warehouse" >>>

Tags: gas compressor station, fuel and lubricants warehouse